| Product | Description | O2 | Loading Capacity | Pressure Drop | Data Sheet | SDS |
|---|---|---|---|---|---|---|
| BAMTM Iron Sponge High capacity H2S removal (up to 10,000 ppm) and some light mercaptans and light organic sulfurs, down to negligible levels. |
A biologically enhanced iron sponge specifically designed for cost-effective and reliable H2S removal from LFG and Biogas resulting from anaerobic digestion and wastewater treatment. Helps meet strict low outlet requirements down to negligible levels, for LFG, WWT, AD biogas and Odor Control. MV Technologies guarantees media performance when used in an H2SPlus System design. | Works both with and without O2. Minimum of 0.5% O2 in gas stream allows for media regeneration and maximum adsorption. | Up to 13-lbs H2S per cubic foot | Range .2 to 1 psi |
BAM Iron Sponge Data Sheet 
|
|
| BAMTM-LPD Iron Sponge High capacity H2S removal (up to 10,000 ppm) and some light mercaptans and light organic sulfurs, down to negligible levels. |
A biologically enhanced iron sponge formulated for applications with minimal horsepower and/or low pressure drop requirement. Treats H2S down to negligible levels, at reduced pressure drop for LFG, WWT, AD, Odor Control. | Works both with and without O2. Minimum of 0.5% O2 in gas stream allows for media regeneration and maximum adsorption | Up to 11-lbs H2S per cubic foot | Reduced Pressure Drop Range .1 to .5 psi | pdf icon | |
| AxTrap-4001/4002 Granular High-capacity H2S removal up to 10,000 ppm. |
Highly porous iron-oxide coated granular media. Formulated to meet stringent LFG and digester gas treatment requirements. Media can be used in systems designed for beneficial end-use such as CHP, fuel for boilers, etc. AxTrap media doesn’t cake together like some other granular media and combined with the SulfAxTM System contributes to even greater ease of removal and |
Works well without O2, however performance is optimized with some oxygen. | Up to 14% wt anaerobic, and 28% wt partially aerobic in Lead/Lag design, otherwise 9-14% in single vessel. | Low Pressure Drop Range .1 to 1 psi |
AxTrap 4001 Data Sheet AxTrap 4002 Data Sheet
|
|
| AxTrap-4003 Granular Resists NMVOCs that may be present in LFG and may interfere with removal efficiency of 4003. |
Built to resist higher levels of non-methane VOCs in landfill gas that can sometimes interfere with reactions with H2S. Does a better job on light mercaptans, if needed. Not for use in California. | Works well without O2, however, performance is optimized with some oxygen. | Up to 14% wt anaerobic, and 21% wt partially aerobic in Lead/Lag design, otherwise 9-14% in single vessel. | Range 0.1 up to 2 psi depending on design. |
AxTrap 4003 Data Sheet
|
AxTrap 4003 SDS
|
| AxTrap-4101/4102 Granular High daily rates of H2S in anaerobic conditions. |
AT 4101/4102 are useful where we have high amounts of H2S to remove per day (normally more than 100 lbs. per day and in anaerobic gas) and need a higher capacity product. | Not necessary. Up to 20% by weight capacity in anaerobic conditions. | Up to 20% wt in anaerobic conditions for Lead/Lag design. | 0.1 up to 2 psi depending on design. | AxTrap 4101 Data Sheet AxTrap 4102 Data Sheet
|
AxTrap 4101 SDS AxTrap 4102 SDS
|
| AxTrap-4011 Granular High daily rates of H2S in anaerobic conditions. |
Deeper removal of organic sulfurs, in this case vent from asphalt plant. AT 4011 is used outside of California and AT 4012 is used in California. | Best for aerobic application such as asphalt vent applications. | Up to 8-12% wt for lower oxygen levels and up to 17% wt for streams with greater than 5:1 ratio of O2:H2S | 0.1 up to 2 psi depending on design.td> | AxTrap 4011 Data Sheet
|
AxTrap 4011 SDS
|